【How To Install】:The bath edging strip can stick to any smooth surface, completely clean and dry the surface before installation(when the temperature is below 20 ℃, you can use a hair dryer for heating to achieve better viscosity).For Long Use, It Is Must To Use Silicone glue To Fill The Edges of the Water Barrier (The Package Do Not Contain Silicone glue)
【High Quality Material】The countertop water retaining strip is made of high-quality silicone material, which is resistant to corrosion, high temperature, and abrasion. The water dam is very easy to clean,just wipe it with a damp cloth.
【Wide Application】: It can be used on shower floors,shower trays,kitchen sinks,under bathroom doors,bathtub edgings,around washing machines or toilets to form a water barrier, effectively stopping the flow of water and achieving wet and dry separation, keep your home away from damp!
【Bendable water-retaining strip】: It can be bent according to the environment to achieve the water-retaining effect. At the corners we recommend cutting to 45 degrees, splicing 90 degrees to paste, the adhesion will be more durable and strong.
【Warm Tips】: Size:20mm W x 12mm H.The silicone floor seal is only 12mm high,which cannot meet the requirements of barrier-free showers and large water holding areas. Waterproof strips are mainly used for bathroom floors, bathroom door bottoms and kitchens.
Product Description
Appilcation:
Sink Countertop,Shower Cubicle,Shower Door Bottom,Bathtub,Shower Floor
Installation method:
Measure:Measure the length and width of the countertop, In the corner, we recommend you cut it to 45 degree, and then connect two part to ensure its firmness.
Tear off the adhesive: in this process avoiding dust on the adhesive strip and affecting its adhesion.
Paste: apply the water dam seal gently and slowly, keeping it horizontal or vertical, pressing gently with your fingers.
Glue:The most important and necessary step is to fill the bottom edge of the water retention strip with caulk to ensure a long-lasting and strong adhesion.
Cautions: In order to achieve stable and lasting effect , please pay attention to the follow question
Purchase a size that is 5cm-10cm longer than the required length !
Clean the ground and dry it before installation!
This floor seal suit for kinds of Smooth flat floor, such as smooth marble floor, coating floor and other smooth surface. can not use for Severe sags and crests floor, big gap floor and Mosaic glass floor.
Not peeling all of sticker one-time: Mark the position and measure suitable length before peeling sticker, peeling sticker little by little one side and then press the peeled position to the surface as the same time, then peeling left little by little. Not peeling all of sticker for one-time and pull up the water retaining strip if found its not install well.
use with silicone sealant: Fill the gap between the walls with the two ends of the water barrier and all around of bottom by silicone sealant to achieve a completely hermetic effect, remove the excess glue to make the contact smooth.
After the installation is completed, it needs to be kept dry for 24 hours, and it needs to be postponed for 1-2 days in autumn and winter.
